Table of Contents
Advertisement
hw-module slot pos
hw-module slot pos
To configure a line card slot for Packet over SONET (POS) operation, use the hw-module slot pos
command in privileged EXEC mode. To remove the configuration for a line card slot, use the no form
of this command.
Syntax Description
slot slot-number
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(11)BC3
Usage Guidelines
You must first use the hw-module slot pos command to preconfigure a line card slot for POS operation
of the Cisco uBR10012 OC-48 DPT card before you can configure the card with any further commands.
You must also use the card 1oc48dpt/pos-1 command to configure the card slot for the proper card type.
Note
If you have previously used the hw-module slot srp command to configure line card slots for Spatial
Reuse Protocol (SRP) operation, you must first cancel that configuration using the no hw-module slot
srp command before you can configure the slots for POS operation using the hw-module slot pos
command.
Examples
The following example shows the Cisco uBR10012 OC-48 DPT line card in slot 3 being configured for
POS operation:
Router# hw-module slot 3 pos
Router# card 3/0 1oc48dpt/pos-1
The following example shows the Cisco uBR10012 OC-48 DPT line cards in slots 3 and 4 being
reconfigured from SRP operation to POS operation:
Router# no hw-module slot 3 srp
Router# no hw-module slot 4 srp
Router# hw-module slot 3 pos
Router# card 3/0 1oc48dpt/pos-1
Router# hw-module slot 4 pos
Cisco Broadband Cable Command Reference Guide
4-24
hw-module slot slot-number pos
no hw-module slot slot-number pos
Resets the line cards that are physically present in the specified slot-number
(valid range is 1 to 8).
Modification
This command was introduced for the Cisco uBR10012 OC-48 Dynamic
Packet Transport (DPT) Interface Module for the Cisco uBR10012 router.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
