Cisco SR2016T-NA Reference Manual page 853

Reference guide
Hide thumbs Also See for SR2016T-NA:
Table of Contents

Advertisement

Chapter 4
Commands for the Cisco uBR10012 Router
Secondary BOOTLDR variable = bootflash:c10k-eboot-mz
Secondary Configuration register is 0x2102
Secondary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Released Version 12.2(11)BC3
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 03-Mar-03 11:28 by texbnt
Router#
The following example shows the same display but after a switchover has occurred. The show
redundancy command now shows that the active (primary) PRE has changed slots (in this case, moving
from slot A to slot B):
Router# show redundancy
PRE A
PRE B (This PRE)
Redundancy state is REDUNDANCY_PEERSECONDARY_INITED
Secondary PRE information....
Secondary is up.
Secondary BOOT variable = bootflash:ubr10k-k8p6-mz
Secondary CONFIG_FILE variable =
Secondary BOOTLDR variable = bootflash:c10k-eboot-mz
Secondary Configuration register is 0x2
Secondary version:
Cisco Internetwork Operating System Software
IOS (tm) 10000 Software (UBR10K-K8P6-M), Released Version 12.2(13)BC2
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled 26 08-Feb-03 11:28 by texbnt
Router#
The following example shows a typical display when the standby PRE1 module is not installed or is not
operational. The standby (secondary) PRE1 module is shown as not up, and its boot variables and
configuration register are not shown.
Router# show redundancy
PRE A (This PRE)
PRE B
Redundancy state is REDUNDANCY_PEERSECONDARY_NONOPERATIONAL
Secondary PRE information....
Secondary PRE is not up
Router#
Clients Display
The following example shows a typical display for the show redundancy clients command:
Router# show redundancy clients
clientID = 0
clientID = 25
clientID = 5
clientID = 50
clientID = 65000
OL-1581-08
: Secondary
: Primary
: Primary
: Secondary
clientSeq = 0
RF_INTERNAL_MSG
clientSeq = 130
CHKPT RF
clientSeq = 170
RFS client
clientSeq = 530
Slot RF
clientSeq = 65000
RF_LAST_CLIENT
Cisco Broadband Cable Command Reference Guide
show redundancy
4-93

Advertisement

Table of Contents
loading

This manual is also suitable for:

Broadband cable

Table of Contents