Table of Contents
Advertisement
cable spectrum-group (global configuration)
The following example shows how to remove a specified spectrum group from your configuration:
Router(config)# no cable spectrum-group 3
Router(config)#
Related Commands
Command
cable modulation-profile
cable spectrum-group hop
period
cable spectrum-group hop
threshold
cable spectrum-group shared
cable upstream frequency
cable upstream power-level
cable upstream shutdown
cable upstream hopping blind
show controllers cable
Cisco Broadband Cable Command Reference Guide
2-234
Description
Configures preset modulation profiles that you can apply to one or
more upstream cable interfaces when you identify and configure
spectrum groups.
Sets the minimum frequency-hop interval for a cable spectrum
group.
Specifies a hop threshold for a cable spectrum group.
Specifies the upstream ports in a spectrum group can share the
same upstream frequency.
Specifies that the upstream should either be set to a specific center
frequency or be set dynamically.
Specifies the upstream cable interface receive power level in
dBmV.
Activates or shuts down a specified upstream cable interface.
Disengages the advanced spectrum management features of the
Cisco uBR-MC16S and Cisco uBR-MC5X20S cable interface line
cards by enabling blind frequency hopping behavior.
Displays information about the cable interface, including the
upstream center frequency.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
