Table of Contents
Advertisement
debug packetcable subscriber
Examples
The following example shows how to enable PacketCable gate control debugging for one specific
PacketCable subscriber at the IP address of 10.10.10.131:
Router# debug packetcable subscriber 10.10.10.131
Router# debug packetcable gate control
Router#
The following example shows how to enable PacketCable events debugging for all PacketCable
subscribers within the 6.6.1.0 subnet:
Router# debug packetcable subscriber 6.6.1.0 255.255.255.0
Router# debug packetcable gate events
Router#
Related Commands
Command
debug cops
debug packetcable all
debug packetcable
cops
debug packetcable
gate
debug packetcable
hccp
debug packetcable ipc
Cisco Broadband Cable Command Reference Guide
5-134
Description
Displays debugging messages related to the COPS protocol.
Displays general debugging messages for all PacketCable events.
Enables debugging of Common Open Policy Service (COPS) messages and
errors that are related to PacketCable operations on the Cisco CMTS router.
Displays general debugging messages related to specific PacketCable gate
events and messages.
Enables debugging messages for events that are related to Hot Standby
Connection-to-Connection Protocol (HCCP) N+1 redundancy
synchronization for PacketCable operations.
Enables interprocess communications (IPC) messages related to
PacketCable operations on the Cisco uBR10012 router.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
