Front Wheel Motor Installation - Toro 22317 Service Manual

31. Using a 3/4" socket, remove the 4 bolts securing the
wheel motor to the mainframe (Fig. 0903).
32. Using the floor jack, lower the wheel motor out of the
frame (Fig. 0904).
33. To service the existing wheel motor, refer to "Parker
/ Ross Wheel Motor Service Manual" (Toro Form No.
492-4753).
Toro Wheeled CUL Service Manual
4-PAW GAS/DRIVE SYSTEM
DSC-0943a
Fig. 0903
DSC-0947a
Fig. 0904

Front Wheel Motor Installation

Note: Upon removal, all seals, o-rings and gaskets
should be replaced. During installation, lightly
lubricate all seals, o-rings and gaskets with
clean petroleum jelly prior to assembly.
1. Place the wheel motor onto a floor jack with the
fittings facing to the side. Position the wheel motor
under the main frame (Fig. 0905).
2. Raise the floor jack and position the wheel motor
into the opening in the main frame so the mounting
holes in the wheel motor align with the mounting
holes in the main frame (Fig. 0906).
DSC-0948a
Fig. 0905
DSC-0950a
Fig. 0906
5/1-7