Toro 22317 Service Manual page 315

4-PAW GAS/HYDRAULICS
16. Start the machine. Allow the air to purge from the
hydraulic system. Check the hydraulic lines and
fittings for leaks. Remove the drain pan.
17. Turn the machine off and remove the key.
18. Slide the rear wheel onto the wheel hub (Fig. 1053).
19. Loosely install 5 lug nuts (tapered side in) (Fig.
1054).
5/2-22
Fig. 1053 DSC-1037a
Fig. 1054 DSC-1035a
20. Torque all 5 lug nuts to 50 + 5ft-lbs. (68 + 7 Nm)
(Fig. 1055).
21. Remove the unit from the jackstands.
22. Raise the loader arms; remove and re-stow the
loader arm cylinder locks.
23. Test operate the machine.
24. Check the hydraulic fluid and add fluid if necessary.
Toro Wheeled CUL Service Manual
Fig. 1055 DSC-1091a