57. Turn the machine on and run it to purge air from the
system. Check for leaks.
58. Raise the loader arm to remove pressure from the
loader arm cylinder locks.
59. Remove the clevis pin and cotter pin from the loader
arm cylinder locks (Fig. 0856).
60. Remove the loader arm cylinder locks from the
cylinder rods (Fig. 0857).
Toro Wheeled CUL Service Manual
CHAIN DRIVE/GAS ENGINE
Fig. 0856
DSC-0455a
Fig. 0857
DSC-0452a
61. Reinstall the loader arm cylinder locks onto the
hydraulic auxiliary lines (for storage) (Fig. 0858).
62. Lower the loader arms.
63. Turn the engine off.
64. Check and add hydraulic fluid to the hydraulic tank
as required.
65. Verify/adjust engine RPM to the following:
• Maximum engine speed (full throttle) to 3600 ± 75
RPM.
• Minimum engine speed (idle) to 1400 ± 200 RPM.
Fig. 0858
DSC-0449a
4/4-29