43. If possible, the piston/seal assembly should sit
at least one hour to allow the seals to elastically
restore.
44. Install the cylinder rod assembly into the barrel (Fig.
0104).
45. Using a spanner wrench, tighten the head into the
barrel (Fig. 0105).
Toro Wheeled CUL Service Manual
IMG-0375a
Fig. 0104
IMG-0519a
Fig. 0105
ALL UNITS/GENERAL
104-4221 Flow Divider Valve Rebuild
1. Loosen the set screw securing the handle to the flow
divider spool. Remove the handle (Fig. 0106).
2. Remove the plugs located on either side of the flow
divider valve (Fig. 0107).
IMG-0523a
Fig. 0106
IMG-0524a
Fig. 0107
3/1-29