4-PAW DIESEL/HYDRAULICS
5. Place absorbent towel inside the chassis under the
right hand counterbalance valve.
6. Using a 1-1/8" crowfoot wrench, remove the rear
wheel motor hydraulic line nut from the upper fitting
on the front of the counterbalance valve (both
marked F) (Fig. 1478).
7. Mark the hydraulic lines on the bulkhead F and R
(Fig. 1479).
F: Front hydraulic line
6/2-44
Fig. 1478
DSC-1893a
Fig. 1479
DSC-1881a
R: Rear hydraulic line
8. Using a 1-1/8" offset wrench, remove the hydraulic
line nut from the bulkhead fitting marked R (Fig.
1480).
9. Using a 1-1/8" offset wrench, remove the hydraulic
line nut from the bulkhead fitting marked F (Fig.
1481).
Toro Wheeled CUL Service Manual
Fig. 1480
DSC-1884a
Fig. 1481
DSC-1902a