Closing The Rear Access Cover; Removing The Side Screens; Installing The Side Screens; Removing The Front Screen - Toro 22306 Operator's Manual

Figure 18
1. Hand knob
2. Tilt the rear access cover down and remove to
access the internal components (Figure 18).
Closing the Rear Access
Cover
1. Move the rear access cover in place over the
back of the traction unit making sure the tabs
line up in the slots.
2. Push the access cover forward, lining up the
hand knob screws with the threaded holes in
the machine.
3. Screw the hand knobs tight to secure the rear
access cover in place.

Removing the Side Screens

1. Open the hood.
2. Slide the side screens (Figure 19) up and out of
the slots in the front screen and frame.
Figure 19
1. Side screen

Installing the Side Screens

Slide the side screens into place in the slots in the
front screen and frame.

Removing the Front Screen

If the engine has been running the heat
shield will be very hot and could burn you.
Allow the traction unit cool completely
before touching the heat shield.
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the front weight
(Figure 20).
Figure 20
1. Front weight
2. Bolts
3. Remove the carriage bolts and nuts securing
the heat shield (Figure 20).
4. Lift the heat shield up and off of the traction
unit.
5. Remove the 4 bolts securing the front screen
to the traction unit frame (Figure 21).
26
3. Heat shield
4. Carriage bolts