CHAIN DRIVE/DRIVE SYSTEM
Wheel Motor Installation
1. Set the wheel motor onto a floor jack with the ports
facing up (Fig. 0503).
2. Slide the floor jack under the machine. Raise the
floor jack and angle the wheel motor shaft up (Fig.
0504).
4/1-64
DSC-0405a
Fig. 0503
DSC-0407a
Fig. 0504
3. Position the wheel motor shaft through the opening
in the frame (Fig. 0505).
4. Continue raising the floor jack and sliding the wheel
motor into the frame aligning the mounting holes
in the wheel motor with the mounting holes in the
frame (Fig. 0506).
Toro Wheeled CUL Service Manual
DSC-0409a
Fig. 0505
DSC-0410a
Fig. 0506