Toro 22317 Service Manual page 96

13. Place the detent spring and large ball into the detent
ball housing (Fig. 0268).
14. Apply lightweight grease to hold the balls in place
during assembly. Place the small detent balls into
the holder. Use a steel rod to push the center ball
down into the holder against the spring pressure
until the detent balls retract (Fig. 0269).
Toro Wheeled CUL Service Manual
DSCN-2482a
Fig. 0268
DSCN-2487a
Fig. 0269
ALL UNITS/GENERAL
15. Then, position the sleeve (large inside diameter first)
over the detent balls (Fig. 0270).
16. Install the detent cover with two Allen screws (Fig.
0271).
Fig. 0270 DSCN-2489a
DSCN-2473a
Fig. 0271
3/1-73