Toro 22317 Service Manual page 324

10. Remove the support from the loader arm.
11. Position the female flush face coupler into the out-
side hole of the coupler bracket on the loader arm
(Fig. 1086).
12. Using a 1-5/16" wrench install the nut to the female
flush face coupler (Fig. 1087).
Toro Wheeled CUL Service Manual
Fig. 1086 DSC-1468
DSC-1470a
Fig. 1087
4-PAW GAS/LOADER ARM
Note: Upon removal, all seals, o-rings and gaskets
should be replaced. During installation, lightly
lubricate all seals, o-rings and gaskets with
clean petroleum jelly prior to assembly.
13. Position the male flush face coupler into the coupler
bracket on the loader arm (Fig. 1088).
14. Using a 1-1/4" wrench and 1-5/16" wrench install the
nut to the male flush face coupler (Fig. 1089).
DSC-1471a
Fig. 1088
DSC-1474a
Fig. 1089
5/3-9