29. Remove the back-up ring from the top and bottom
bushings (Fig. 0205).
30. Remove the gear seal from the top and bottom
bushings (Fig. 0206).
Note: Lubricate all surfaces on reassembly.
Toro Wheeled CUL Service Manual
IMG-0246a
Fig. 0205
IMG-0247a
Fig. 0206
ALL UNITS/GENERAL
31. Install the gear seal with the lip side of the gasket
facing away from the groove of the bushing (Fig.
0207).
32. Install the back-up ring into the bushing so that it
rests in the lip of the gear seal (Fig. 0208).
IMG-0249a
Fig. 0207
IMG-0251a
Fig. 0208
3/1-57