Toro 22317 Service Manual page 420

5. Install the hydraulic lines to the lift cylinder fittings,
with the hydraulic line (A) installed to the upper
cylinder fitting (Fig. 1421).
Note: Use double wrenches to prevent the hose
from twisting while tightening.
6. Install the pivot pin through the ram end pivot point
and loader arm (Fig. 1422).
Note: If there is a misalignment in the pivot points,
start the machine and activate the hydraulic
lift lever to raise the lift arm. Remove the
cylinder lock from the other lift cylinder and
carefully align the pivot points to install the
pivot pin.
Toro Wheeled CUL Service Manual
4-PAW DIESEL/HYDRAULICS
Fig. 1421 IMG-0107a
Fig. 1422 IMG-0096a
7. Align the pivot pin through hole with the mounting
hole in the cylinder. Install a shoulder bolt to secure
the pivot pin. Torque the shoulder bolt to 150 to 179
in-lbs. (17 – 19 Nm) (Fig. 1423).
8. Grease the top and bottom pivot pins and bushing
assemblies using general purpose grease (Fig.
1424).
9. Start the machine and raise the lift arm. Remove the
cylinder lock.
10. Purge the system and check for leaks.
11. Turn the machine off and remove the key.
12. Check the hydraulic oil and add as necessary.
Fig. 1423 IMG-0108a
Fig. 1424 IMG-0109a
6/2-29