Toro 22317 Service Manual page 356

54. Fill the engine with oil:
a. Remove the oil fill cap and slowly pour
approximately 80% of the specified amount of oil
in through the valve cover.
b. Clean around the oil dipstick (Fig. 1203).
c. Pull out the dipstick and wipe the metal end
clean (Fig. 1203).
d. Slide the dipstick fully into the dipstick tube (Fig.
1203).
e. Pull the dipstick out and look at the metal end.
f. If the oil level is low, clean around the oil filler
cap and remove the cap (Fig. 1203).
g. Slowly pour only enough oil into the valve cover
to raise the level to the F (full) mark.
Important: Overfilling the crankcase could damage
the engine.
h. Replace the filler cap and dipstick.
B
A
C
A. Oil dipstick
B. Filler cap
Toro Wheeled CUL Service Manual
D
fig. 7 G005157
Fig. 1203
C. Valve cover
D. Metal end
4-PAW GAS/ENGINE
55. Check the hydraulic fluid level:
Hydraulic Tank Capacity: 17.25 US gallons (67 l)
a. Use 10W-30 or 15W-40 detergent, diesel engine
oil (API service CH-4 or higher).
b. Clean the area around the filler neck of the
hydraulic tank (Fig. 1204).
c. Remove the cap from the filler neck and check
the fluid level on the dipstick (Fig. 1204).
d. The fluid level should be between the marks on
the dipstick.
e. If the level is low, add enough fluid to raise it to
the proper level.
f. Install the cap on the filler neck.
A. Filler neck cap
A
B
fig. 8 G005158
Fig. 1204
B. Dipstick
5/4-27