Ignition Switch (P/N 103990)
Purpose
This component provides the proper switching for the
starter, ignition, accessories, and safety circuits.
Location
The ignition switch is mounted on the right hand side of
the upper frame assembly (Fig. 1208).
Toro Wheeled CUL Service Manual
Fig. 1208
DSC-1370
4-PAW GAS/ELECTRICAL
How It Works
Detents inside the ignition switch give it 3 positions: OFF,
RUN, and START. The START position is spring loaded
so the cylinder automatically returns to RUN once the
key is released.
Testing
1. Disconnect the switch from the wiring harness.
2. Verify that continuity exists between the terminals
listed for the START and RUN switch positions.
Verify that there is NO continuity between the
terminals in the OFF switch position (Fig. 1209).
Position
OFF
RUN
START
A
R
I
B
S
Fig. 1209
Condition
No continuity
B + R + I + A
B + R + I + S
IMG-0557a
5/5-1