Toro 22317 Service Manual page 209

CHAIN DRIVE/HYDRAULICS
6. Align the ram end of the cylinder with the loader arm
pivot point. Insert the pivot pin into the pivot point
(Fig. 0681).
Note: If the holes on the ram end of the cylinder and
the lift arm pivot point are not aligned, start
the unit and raise the lift arm. Remove the
cylinder lock and carefully align the holes so
that the pivot pin can be installed. Replace
the cylinder lock after the pivot pin has been
installed.
7. Install a shoulder bolt to secure the pivot pin. Torque
the shoulder bolt to 150 - 179 in-lbs (17 - 20 Nm)
(Fig. 0682).
4/2-40
Fig. 0681 DSC-2906a
Fig. 0682 DSC-2929a
8. Grease the top and bottom pivot pins and bushing
assemblies (Fig. 0683).
9. Start the unit and raise the lift arm. Remove the
cylinder lock.
10. Purge the system and check for any leaks.
11. Check the hydraulic fluid and add if necessary.
Toro Wheeled CUL Service Manual
Fig. 0683 DSC-2930a