9. Inspect the hub and sprocket. If worn or damaged,
replace. Refer to "Sprocket Replacement" on page
4/1-35.
10. Inspect the seals and bearings. If worn or damaged,
replace. Refer to "Front Axle Hub Rebuild" on page
4/1-46.
11. Apply grease to the inside of the seal (Fig. 0347).
12. Grease the axle seal surface (Fig. 0348).
Toro Wheeled CUL Service Manual
CHAIN DRIVE/DRIVE SYSTEM
DSC-0317a
Fig. 0347
DSC-0554a
Fig. 0348
13. Slide the front hub and sprocket assembly onto the
axle (Fig. 0349).
14. Slide the outer bearing over the axle and into the
hub (Fig. 0350).
DSC-0326a
Fig. 0349
DSC-0327a
Fig. 0350
4/1-21