Toro 22317 Service Manual page 72

34. Remove the rod from the vise and secure the
cylinder barrel into the vise.
35. Install the ram assembly into the cylinder barrel by
rotating the head assembly while pushing the head
into the barrel (Fig. 0174).
36. Continue rotating the head until the ring hole in
the ring groove is within the slot on the barrel (Fig.
0175).
Toro Wheeled CUL Service Manual
IMG-0366a
Fig. 0174
IMG-0367a
Fig. 0175
ALL UNITS/GENERAL
37. Insert the tab end of the retaining ring through the
notch in the barrel and into the hole in the groove of
the head. Place the spanner wrench onto the head
assembly (Fig. 0176).
38. Begin rotating the spanner wrench clockwise so that
the head pulls the ring inside the barrel. Continue
rotating until the ring is completely installed the
barrel on the head assembly (Fig. 0177).
IMG-0368a
Fig. 0176
IMG-0321a
Fig. 0177
3/1-49