ALL UNITS/GENERAL
9. Remove the drive gear (gear with splines) from the
pump assembly (Fig. 0185).
10. Remove the driven gear from the pump assembly
(Fig. 0186).
3/1-52
IMG-0223a
Fig. 0185
IMG-0224a
Fig. 0186
11. Using a needle nose pliers grab the center of the
inner small bushing and lift it partially out of the
pump housing (Fig. 0187).
12. Mark the inner small bushing assembly with a line
that extends out onto the pump housing. This line
should be on the opposite side as the previous
marking (Fig. 0188).
Toro Wheeled CUL Service Manual
PICT-2834b
Fig. 0187
PICT-2835a
Fig. 0188