4-PAW DIESEL/HYDRAULICS
6. Place absorbent towel inside the chassis under the
left hand counterbalance valve.
7. Using a 1-1/8" offset wrench, remove the hydraulic
line nut marked F from the bulkhead fitting (Fig.
1448).
8. Using a 1-1/8" offset wrench, remove the hydraulic
line nut from the front, top counterbalance valve
fitting (Fig. 1449).
6/2-36
Fig. 1448
DSC-1789a
Fig. 1449
DSC-1791a
9. Lay the (F) hydraulic line to the side in the chassis.
10. Using a 1-1/8" offset wrench, remove the hydraulic
line nut marked R from the front, bottom counter-
balance valve fitting (Fig. 1450).
11. Using a 1-1/8" offset wrench, remove the hydraulic
line nut marked R from the bulkhead fitting (Fig.
1451).
Toro Wheeled CUL Service Manual
Fig. 1450
DSC-1792a
Fig. 1451
DSC-1796a