Gas Engine Replacement
Gas Engine Removal
1. Start the engine and let it run for five minutes to
warm the engine oil.
2. Park the traction unit so that the drain side (rear left
corner) is slightly lower than the opposite side to
ensure that the oil drains completely.
3. Raise the loader arms to the fully raised position.
4. Turn off the engine and remove the key.
5. Remove the loader arm cylinder locks located on the
hydraulic auxiliary lines (Fig. 0748).
Toro Wheeled CUL Service Manual
CHAIN DRIVE/GAS ENGINE
Fig. 0748
DSC-0448a
6. Position a loader arm cylinder lock over each lift
cylinder rod (Fig. 0749).
7. Secure each loader arm cylinder lock with a clevis
pin and hairpin cotter (Fig. 0750).
Fig. 0749
DSC-0452a
Fig. 0750
DSC-0455a
4/4-1