Servicing The Fuse; Drive System Maintenance; Checking The Tire Treads; Checking The Wheel-Lug Nuts - Toro e-Dingo 500 Operator's Manual

Servicing the Fuse

1. Park the machine on a level surface.
2. Raise the loader arms and install the cylinder
locks.
3. Shut off the machine and remove the key.
4. Remove the hood; refer to
(page 28).
5. Disconnect the main power to the machine; refer
to Disconnecting the Main Power (page
6. Locate the fuse and replace it
Figure 33
7. Torque the nuts to 12 to 18 N∙m (9 to 13 ft-lb).
8. Connect the main-power connectors.
9. Install the front cover.
Removing the Hood
29).
(Figure 33).
g304512
32
Drive System
Maintenance

Checking the Tire Treads

Service Interval: Before each use or daily
Check the tire treads for wear. Replace the tires when
the treads are worn and shallow.
Checking the Wheel-Lug
Nuts
Service Interval: After the first 8 hours
Every 100 hours
Check and torque the wheel lug nuts to 68 N∙m (50
ft-lb).