Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
show voice port
To display configuration information about a specific voice port, use the show voice port command in
privileged EXEC mode.
Cisco uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description
number
Command Modes
Privileged EXEC
Command History
Release
12.0(4)XL
12.1(5)XU1
12.2(2)XA
Examples
The following example shows typical output from the show voice port command for a cable access
router:
Router# show voice port 0
Foreign Exchange Station 0
Type of VoicePort is FXS
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to -2 dB
Out Attenuation is Set to 0 dB
Echo Cancellation is enabled
Echo Cancel Coverage is set to 8 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 10 s
Interdigit Time Out is set to 10 s
Call-Disconnect Time Out is set to 60 s
Ringing Time Out is set to 180 s
Region Tone is set for US
Analog Info Follows:
Currently processing none
Maintenance Mode Set to None (not in mtc mode)
Number of signaling protocol errors are 0
Impedance is set to 600r Ohm
OL-1581-07
show voice port number
Identifies the voice port. Valid entries are 0 (which corresponds to the RJ-11
connector labeled V1) and 1 (which corresponds to the RJ-11 connector labeled
V2).
Modification
This command was introduced for the Cisco uBR924 cable access router.
Support was added for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
Cisco Broadband Cable Command Reference Guide
show voice port
6-177
Advertisement
Table of Contents
