Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
Debug Commands
This section describes the following debug commands, which are not normally needed to install or
configure the Cisco cable CPE devices. These commands are used to troubleshoot the device's
installation or configuration.
•
•
•
•
•
•
•
•
•
•
•
•
Additional debug commands are documented in the Cisco IOS Debug Command Reference, available on
Cisco.com and the Documentation CD-ROM.
The debug commands are primarily intended for use in controlled test and troubleshooting situations
Caution
with a limited volume of traffic. You should use caution when enabling debug messages because sending
these messages to the console consumes system resources. Turning on too many types of debug messages
can adversely affect the router's network performance, depending on what messages are being displayed
and the type of traffic that is occurring.
OL-1581-07
debug cable-modem bpkm
debug cable-modem bridge
debug cable-modem error
debug cable-modem interrupts
debug cable-modem mac log
debug cable-modem mac messages
debug cable-modem mac messages dynsrv
debug cable-modem map
debug cable-modem up-dis
debug crypto ipsec client ezvpn
debug docsis ssd
debug usb
Cisco Broadband Cable Command Reference Guide
Debug Commands
6-183
Advertisement
Table of Contents
