Position Switches - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters

16.19 Position Switches

(Note) The parameters #7741 to #7814 (position switch No. 25 to 32) are only for C80.
#7500 Pcheck
Specify whether to perform position switch area checking at high speeds.
0: Do not perform position switch area checking at high speed (do it the same as before).
1: Perform position switch area checking at high speed.
[C80]
For C80, whether the setting is "0" or "1", the operation of "1" is always performed.
#7501+10(n-1)
"n" represents the posistion switch No.(n=1 to 24)
Specify the name of the axis for which a position switch is provided.
---Setting range---
[M8]
X, Y, Z, U, V, W, A, B, or C axis address
[C80]
NC axis: the NC axis address such as X, Y, Z, U, V
PLC axis: the PLC axis No. such as 1, 2, 3, 4, 5, 6, 7, 8
#7502+10(n-1)
"n" represents the posistion switch No.(n=1 to 24)
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to the PLC.
For the device No., refer to the PLC Interface Manual.
---Setting range---
-99999.999 to 99999.999 (mm)
#7503+10(n-1)
"n" represents the posistion switch No.(n=1 to 24)
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to the PLC.
For the device No., refer to the PLC Interface Manual.
---Setting range---
-99999.999 to 99999.999 (mm)
#7504+10(n-1)
"n" represents the posistion switch No.(n=1 to 24)
When position switch area checking at high speed is selected, specify the mode of area checking, i.e., wheth-
er to use the command type machine position or detector feedback position, for each position switch.
0: Use the command type machine position as the machine position for position switch area checking.
1: Use the detector feedback position as the machine position for position switch area checking.
[M8]
(Note) This parameter is valid only when "1" set in "#7500 Pcheck".
#7741+10(n-25)
[C80]
"n" represents the posistion switch No.(n=25 to 32)
Specify the name of the axis for which a position switch is provided.
---Setting range---
PLC axis: the PLC axis No. such as 1, 2, 3, 4, 5, 6, 7, 8
PSWn axis
PSWn dog1
PSWn dog2
PSWn check
PSWn axis
643
High-speed switching of position switch
Axis name
Imaginary dog position 1
Imaginary dog position 2
Selection of area check method
Axis name
IB-1501279-H