Cycle Start Prohibit (Op Error); Cycle Start Prohibit(Sbt Warn); Cycle St. Prohibit (Term Exp'd); Cycle Start Disabled (In Sbt) - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

2 Stop Codes (T)

Cycle start prohibit (OP error)

Cycle start was executed during operation error where cycle start cannot be executed.

After canceling operation error, execute cycle start.

Cycle start is disabled because the axis in SBT warning exists in the system.

After cancelling the SBT warning, execute the cycle start.

Cycle start prohibit

Automatic start is not possible because the setting of setup parameters is enabled.

Refer to the manual issued by the machine tool builder.

Cycle start prohibit

Automatic start was attempted while a file was being deleted/written.

Wait for the file to be deleted/written and then execute the automatic start.

Automatic start is not possible because the valid term has been expired.

Obtain a decryption code from the machine tool builder and input it in the NC, then turn the power ON

Cycle start is disabled because the break test is being executed for some axes in the system.

Execute cycle start after the break test is completed.

Cycle start prohibit(in SBT)

Cycle start is disabled because the axis in brake test exists in the system.

After the brake test completed, execute the cycle start.

H/W stroke end axis exists

An axis is at the stroke end.

Manually move the axis away from the stroke end limit switch.

Correct the machining program.

S/W stroke end axis exists

An axis is at the stored stroke limit.

Manually move the axis.

Correct the machining program.

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series