Mitsubishi Electric M800 Series Manual page 411

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1227 aux11
bit0: Select PLC signal or spindle feedrate attained
Set up this option when disabling the cutting start interlock by spindle feedrate attained.
0: Cutting start interlock by PLC signal
1: Cutting start interlock by spindle feedrate attained
bit1: Select H or D code
Set up this option to validate the data that is set up on the tool life management screen when issuing the H99
or D99 command.
0: The H and D codes validate the data that is set up on the management setup screen.
1: Validates the data that is set up on the management setup screen when issuing the H99 or D99 com-
mand.
bit2: Measures against tool setter chattering
Select a condition where a relieving operation completes after measurement with tools.
0: Sensor signals have stopped for 500 ms or longer.
1: 100 μm or longer has passed after sensor signals stopped.
bit3:
Not used.
bit4: Word command check
Select whether to output an error when no numeric value follows a program address during execution of a
machining program.
0: Not check
1: Check
bit5: Spindle rotation speed clamp
Specify whether to clamp the rotation speed in constant surface speed mode when the spindle rotation clamp
command is issued.
0: Clamps the rotation regardless of the constant surface speed mode.
1: Clamps the rotation only in constant surface speed mode.
bit7: Switch the range of tool life data to be input
Set up the range of tool life data to be input or compared.
0: Inputs or compares all of the data output.
1: Inputs or compares part of the data output
1) Tool life management I data to be input or compared tool number (D), lifetime (E), life count (F), and aux-
iliary data (B).
2) Tool life management II data to be input or compared Group number (G), method (M), life (E/F), tool num-
ber (D), and compensation number (H)
IB-1501279-H 394