Invld Manual Interrupt In G6.2; Invalid Restart During G06.2; Fairing Changeover Disabled; Skip Axis Illegal - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P554

Invld manual interrupt in G6.2

Details
Manual interruption was executed in a block that applies the G06.2 mode.
Remedy
Execute the manual interruption in the block that does not apply the G06.2 mode.
P555

Invalid restart during G06.2

Details
Restart was attempted from the block that applies G06.2 mode.
Remedy
Restart from the block other than in G06.2 mode.
P560

Fairing changeover disabled

Details
A command to enable the fairing function was given while the smooth fairing function was ON.
A command to enable the smooth fairing function was given while the fairing function was ON.
Remedy
Correct the program.
P595

Skip axis illegal

Details
No axis or more than 2 axes was/were issued to torque limitation skip command block.
An axis during synchronous control was issued as the skip axis.
An axis during inclined axis control was issued as the skip axis.
Geometric command, corner R, or corner chamfering was issued in the same block as torque limitation
skip command.
A torque skip was commanded to the axis which is in the constant torque control or the proportional torque
stopper control.
Remedy
Issue only an axis to the skip axis.
Review the program.
P600 No spec: Auto TLM
Details
An automatic tool length measurement command (G37) was issued though it is out of specifications.
Remedy
Check the specifications.
P601 No spec: Skip
Details
A skip command (G31) was issued though it is out of specifications.
Remedy
Check the specifications.
P602 No spec: Multi skip
Details
A multiple skip command (G31.1, G31.2, G31.3 or G31 Pn) was issued though it is out of specifications.
Remedy
Check the specifications.
P603 Skip speed 0
Details
The skip speed is "0".
Remedy
Specify the skip speed.
IB-1501279-H 152