Superimposition Command Illegal; G114.N Command Illegal; Spindle In-Use By Synchro Tap; Gb Spindle Synchro Signal Off - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Superimposition command illegal

Details
Superimposition start command was issued to the axis which is executing the following functions.
Synchronization control
Milling interpolation
Feed-forward thread cutting control
Superimposition start command was issued to the axis which was under superimposition control.
The superimposition command was issued to an axis that belongs to the same part system as a basic or
synchronous axis of synchronization across part systems.
Remedy
Correct the program.
Turn OFF the feed-forward control request signal.
M01

G114.n command illegal

Details
G114.n has been commanded during the execution of G114.n.
G51.2 has been commanded when G51.2 spindle-spindle polygon machining mode has been already entered
at another part system.
Multiple spindle synchronization set command is illegal.
Remedy
Command G113 to cancel the operation.
Turn ON the "spindle synchronization cancel" signal (Y18B8: SPSYC) to cancel the operation.
Command G50.2 to cancel the operation.
Turn ON the "spindle-spindle polygon cancel" signal (YCD1) to cancel the operation.
Correct the program.
M01

Spindle in-use by synchro tap

Details
The spindle is being used in synchronized tapping.
Remedy
Cancel the synchronized tapping.
M01

GB spindle synchro signal OFF

Details
A forward run, reverse run, orientation, synchronous tapping, spindle synchronization, tool spindle syn-
chronization I, tool spindle synchronization II or C-axis servo ON command was issued to the reference
spindle while the guide bushing spindle synchronization signal was OFF.
The guide bushing spindle synchronization signal was turned OFF during a forward run, reverse run, ori-
entation, synchronous tapping, spindle synchronization, tool spindle synchronization I, tool spindle synchro-
nization II or C-axis servo ON command.
Orientation was commanded during the "guide bushing spindle synchronization" signal ON with spindle
zero point detection with proximity switch and turret indexing enabled.
C axis servo ON was commanded during the "guide bushing spindle synchronization" signal ON with spin-
dle C axis parameter change enabled.
Remedy
Check the ladder program.
Check the parameters.
M01 GB SP sync:Spindle type error
Details
An analog spindle analog spindle is used for the master spindle or the guide bushing spindle.
Spindle-mode servo is used for the master spindle or the guide bushing spindle.
Turret gear change control valid spindle is used for the master spindle or the guide bushing spindle.
Remedy
Check the parameters.
Change the reference spindle or the guide bushing spindle to spindle drive unit.
Change the reference spindle or the guide bushing spindle to turret gear change control invalid.
IB-1501279-H 24
1004
1005
1007
1014
1015