Vbl2 Vbound; Vbl2 Compmag; Vbl2 Compmul; Vbl2 Ble - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2574

VBL2 VBound

Set the boundary value of the speed in calculating the compensation amount.
---Setting range---
1 to 1000000 (mm/min)
#2575

VBL2 CompMag

Set the compensation magnification in calculating the compensation amount. When "0" is set, the magnifi-
cation is 100%.
---Setting range---
0 to 300 (%)
#2576

VBL2 CompMul

Set the multiplier in calculating the compensation amount. When "1000" is set, the multiplier is "1".
---Setting range---
0 to 1000 (1/1000)
#2577

VBL2 BLE

Set the value to subtract from the compensation amount (CMP) at reversing the axis travel direction.
---Setting range---
-99999999 to 99999999 (Machine error compensation unit)
#2578 VBL2 BLL
Set the travel distance to return to the compensation amount (CMP) from the reverse point of the axis travel
direction.
---Setting range---
0 to 99999.999 (mm)
#2579 BLAT_feed
[M8]
Set the feed rate in adjusting the backlash amount.
It is possible to set this parameter also by carrying out a measurement condition adjustment on the backlash
adjustment screen.
---Setting range---
0 to 1000000 (mm/min)
(PR) #2580 index_Gcmd
The commanded G code of the index table indexing axis is checked.
0: Check is not performed.
1: Cutting feed G command is prohibited.
#2581 BLAT_pos
[M8]
Set the measurement position in measurement condition adjustment and backlash adjustment on the ma-
chine coordinate system.
(Note 1) Set the position so that a collision will not occur during adjustment.
(Note 2) Set this parameter for all the axes.
---Setting range---
-99999.999 to 99999.999 (mm)
IB-1501279-H
Variable backlash comp II Speed boundary value
Variable backlash comp II Compensation magnification
Variable backlash comp II Multiplier in calculating com-
pensation amount
Variable backlash comp II Gradually increase amount
Variable backlash comp II Gradually increase travel dis-
tance
Feed rate for automatic backlash adjustment
Indexing axis G command check
Measurement position for automatic backlash adjust-
ment
496