Mitsubishi Electric M800 Series Manual page 439

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1278 ext14
bit0: Program restart method selection
Select the program restart type.
0: Restart type A
1: Restart type B
bit1: Change miscellaneous command completion method
Select the complete signal and completion condition.
0: Normal method
Complete at the falling edge of M function finish 1 signal (FIN1) or rising edge of M function finish 2
(FIN2).
1: High-speed method
Complete when High-speed M finish signal (MFIN1 to 4, SFIN1 to 6, TFIN1 to 4 or BFIN1 to 4) reaches
the same logical level as the strobe signal.
bit2: Change areas for stored stroke limit I
Enable/Disable change of the areas for stored stroke limit I.
0: Disable
1: Enable
bit3: Select M30 rewinding operation
Select the operation when the miscellaneous function completed signal (FIN) is returned to M30.
0: Not carry out automatic rewinding
1: Carry out automatic rewinding
bit4: Select M02 rewinding operation
Select the operation when the miscellaneous function completed signal (FIN) is returned to M02.
0: Not carry out automatic rewinding
1: Carry out automatic rewinding
bit5: M code output during high-speed simple program check
Select whether to enable M code output during high-speed simple program check.
The M codes to be output are those specified by "#1451 M[M031-000](SMLK)" to "#1466 M[M511-480](SM-
LK)".
0: Disable
1: Enable
bit7: Operation for circular radius error at perfect circle command
Select the operation to be performed when a perfect circle command is given and there is a difference be-
tween the start point and end point radii, but no difference between the start point and end point angles.
0: Linear interpolation from the start to the end point
1: Spiral interpolation from the start to the end point
IB-1501279-H 422