N/A During High-Cycle Sampling; Invalid Cmd During Param Write; Sp Orient. Z Detection Error; Illegal Movement Command During Superimposition - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

N/A during high-cycle sampling

Details
An attempt to activate "Speed monitor mode" was made during the high-cycle sampling mode.
An attempt to change the gear signal was made during the high-cycle sampling mode.
An attempt to execute spindle orientation was made during the high-cycle sampling mode.
Spindle detach was attempted during the high-cycle sampling mode.
Any of the following operations was attempted during the high-cycle sampling mode: Dog-type zero point
return, absolute position setting, spindle/C axis changeover, synchronous tapping, spindle synchronization,
hobbing, or tool spindle synchronization IC.
Remedy
Change the speed monitor mode signal back, finish high-cycle sampling, and then select the speed mon-
itor mode.
Change the gear signal back, finish high-cycle sampling, and then change the gear.
Change the spindle orientation signal back, finish high-cycle sampling, and then execute orientation.
Change the spindle detach signal back, finish high-cycle sampling, and then carry out spindle detachment.
Execute the operation after terminating high-cycle sampling.
M01

Invalid cmd during param write

Details
A function which is unavailable during parameter write was commanded.
Spindle/C axis changeover
Speed observation mode signal ON
High-speed synchronous tapping
PLC axis indexing
Remedy
Cancel the write of the parameter.
Command the following functions after the parameter write is completed.
- Spindle/C axis changeover
- Speed observation mode signal ON
- High-speed synchronous tapping
- PLC axis indexing
M01

SP orient. Z detection error

Details
Z phase detection has failed to be completed during execution of proximity-switch orientation.
Remedy
Check for a failure of the proximity switch.
M01

Illegal movement command during superimposition

Details
A machine command was issued to the superimposing axis.
Reference position return was attempted on the superimposing axis.
Skip command was issued to the master or superimposing axis.
Dog-type reference position return was attempted on the master axis.
Remedy
Correct the program.
0292
23
0291
(Axis name)
0301
1003
IB-1501279-H