No Spec: High-Accuracy Control; No Spec: Inverse Time Feed; G93 Mode Error; Invalid Cmnd In High-Accuracy - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P123

No spec: High-accuracy control

Details
High-accuracy control command was issued though it is out of specifications.
Remedy
Check the specifications.
P124

No spec: Inverse time feed

Details
The inverse time option is not provided.
Remedy
Check the specifications.
P125

G93 mode error

Details
The issued G code command is illegal during G93 mode.
G93 command was issued during a modal for which inverse time feed cannot be performed.
Remedy
Correct the program.
P126

Invalid cmnd in high-accuracy

Details
An illegal command was issued during the high-accuracy control mode.
A G code group 13 command was issued during the high-accuracy control mode.
Milling, cylindrical interpolation or pole coordinate interpolation was commanded during the high-accuracy
control mode.
Remedy
Correct the program.
P127 No spec: SSS Control
Details
The SSS control valid parameter has been set although there is no SSS control specification.
Remedy
Check the specifications. Set "#8090 SSS ON" to "0" when there is no SSS control specification.
P128 Machin condtn select I disable
Details
Machining condition selection I was commanded during the mode where the selection command is unavailable.
Remedy
Check the program and see whether any unavailable mode is included during machining condition selec-
tion I. If any, cancel that mode.
P129 Hi-speed Hi-accuracy both ON
Details
Both the high-accuracy control mode and high-speed machining mode are commanded simultaneously in a
part system where the simultaneous use of the two modes is disabled.
Remedy
Correct the setting of "#8040 High-speed high-accuracy control-enabled part system". Or correct the ma-
chining program so that the high-accuracy control mode is not used together with high-speed machining
mode.
P130 2nd M function code illegal
Details
The 2nd miscellaneous function address, commanded in the program, differs from the address set in the pa-
rameters.
Remedy
Correct the 2nd miscellaneous function address in the program.
IB-1501279-H 130