M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P436
G29 and M commands in a block
Details
An M command was issued simultaneously in the G29 command block.
Remedy
Place the M code command, which cannot be issued in a G29 command block, in separate block from G29
command block.
P438
G52 invalid during G54.1
Details
A local coordinate system command was issued during execution of the G54.1 command.
Remedy
Correct the program.
P450
No spec: Chuck barrier
Details
The chuck barrier on command (G22) was specified although the chuck barrier is out of specifications.
Remedy
Check the specifications.
P451
No spec: Stroke chk bef travel
Details
Stroke check before travel (G22/G23) was commanded though it is out of specifications.
Remedy
Check the specifications.
P452
Limit before travel exists
Details
An illegal command, which places the axis travel start/end point in the prohibited area or moves the axis
through the prohibited area, was detected when Stroke check before travel (G22) was commanded.
Remedy
Correct the coordinate values of the axis address commanded in the program.
P460
Tape I/O error
Details
An error has occurred in the tape reader. Otherwise an error has occurred in the printer during macro printing.
Remedy
Check the power and cable of the connected devices.
Correct the I/O device parameters.
P461
File I/O error
Details
A file of the machining program cannot be read.
Remedy
In memory mode, the programs stored in memory may have been destroyed. Output all of the programs
and tool data and then format the system.
Ensure that the external device (including SD card/USB memory) that contains the file is mounted.
Correct the parameter settings for HD operation, SD card operation or USB memory operation.
P462
Computer link commu error
Details
A communication error occurred during the BTR operation.
Remedy
"L01 Computer link error" is displayed simultaneously. Take the remedy corresponding to the error No.
147
IB-1501279-H