M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8215
TLM std length
Set the TLM standard length.
TLM standard length is the distance from a tool replacement point (reference position) to the measurement
basic point (surface) which is used to measure the tool length.
(The same value as "#2016 tlml+" will be reflected. When either setting changes, the other will change ac-
cordingly.)
---Setting range---
-99999.999 to 99999.999 (mm)
#8216
Type in G28 return
Select the performance after establishing the reference position in reference position return command.
0: Moves to the reference position.
1: Won't move to the reference position.
#8217
Check start point
[M8]
Set a drawing start position in graphic check of each axis.
Set a distance from actual machine position by an incremental value.
When "0" is set, an actual machine position will be regarded as a start point in graphic check.
---Setting range---
-99999.999 to 99999.999 (mm)
[C80]
Not used.
#8218
Dir cmd retrct amt
Set in which direction and how much the tool escapes when the operation is halted during direct command
mode. (Radius value)
The tool does not escape when "0" is set.
---Setting range---
-99999.999 to 99999.999 (mm)
#8219
Hob retract amount 1
Set the retract amount using the radius value when the Hob retract amount selection signal is OFF.
Retract is carried out in the negative direction if a negative value is set.
---Setting range---
-99999.999 to 99999.999 (mm)
#8220
Hob retract amount 2
Set the retract amount using the radius value when the Hob retract amount selection signal is ON.
Retract is carried out in the negative direction if a negative value is set.
---Setting range---
-99999.999 to 99999.999 (mm)
#8221
Hob retract speed
Set the retract speed during hobbing.
---Setting range---
1 to 1000000 (mm/min)
(PR)
#8224
Posn display range
Current position display range
Select the display range of the current position.
0: 0 to 359.999 deg
1: -99999.999 to 99999.999 deg
253
IB-1501279-H