Mitsubishi Electric M800 Series Manual page 445

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1286 ext22
bit2: O No. for program input No.
Select the operation when the same program No. is input during data input.
0: The O No. is handled as a character string data.
1: The O No. is handled as a program No. Whether to overwrite the program or cause an error is decided
by "#1218 bit7 Input by program overwrite".
bit3: No O No. at machining program input
Select whether to enable the machining program input even if there is no program No. (O No.).
The program No. is fixed to 01 in this case.
0: Disable
1: Enable
bit5: Selection of multi-part system program input/output method
Select whether to perform the transfer from NC memory to other device for all the part systems or for each
part system separately in multi-part system program management.
0: Output the designated programs for all the part systems.
(The programs output from NC memory contain the system delimiter $ marks.)
1: Output the programs of only the selected part system.
IB-1501279-H 428