Mitsubishi Electric M800 Series Manual page 369

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1195 Mmac
Select whether to enable or disable M command macro call of user macro.
0: Disable
1: Enable
#1196 Smac
Select whether to enable or disable S command macro call of user macro.
0: Disable
1: Enable
#1197 Tmac
Select whether to enable a call of user macro using command T.
0: Disable macro call
1: Enable macro call, irrespective of the number of command T digits
2: Enable macro call when a tool No. (excluding 0) is given to the upper digit of command T
3: Enable macro call when a tool No. (including 0) is given to the upper digit of command T.
#1198 M2mac
Select whether to enable or disable 2nd miscellaneous command macro call of user macro.
0: Disable
1: Enable
#1199 Sselect
Select the initial condition of spindle control after power is turned ON.
0: 1st spindle control mode (G43.1)
1: 2nd spindle control mode (G44.1)
2: All spindle simultaneously control mode (G47.1)
(Note) While G43.1 or G44.1 command is given, the spindle No. is selected with "#12090 SnG43.1" or "#1534
SnG44.1".
(PR) #1200 G0_acc
Select the acceleration and deceleration type when a rapid traverse command is issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
(Note) When rapid traverse constant inclination multi-step acceleration/deceleration is valid, this parameter
will be invalid.
(PR) #1201 G1_acc
Select the acceleration and deceleration type when a linear interpolation command is issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
#1202 mirofs
Set the distance between tools (edges) (between facing turrets).
---Setting range---
0 to 99999.999 (mm)
#1203 TmirS1
Select the turrets, which correspond to the tool Nos. 1 to 32, as facing turrets for T code mirror image.
---Setting range---
0 to FFFFFFFF
IB-1501279-H
Macro call for M command
Macro call for S command
Macro call by command T
Macro call with 2nd miscellaneous code
Select initial spindle control
Validate acceleration and deceleration with inclination
constant G0
Validate acceleration and deceleration with inclination
constant G1
Distance between facing turrets (for L system only)
Select turrets as facing turrets with T command (for L
system only)
352