Keep G43 Mdl M-Ref; H-Spd Retract On; Mirr Img At Reset; Check Scode In G84 - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8122

Keep G43 MDL M-REF

Select whether to keep the tool length offset by high speed manual reference position return during tool
length offset.
0: Will not be kept (Cancel)
1: Kept
#8123

H-spd retract ON

Select whether to enable the drilling cycle at high-speed retract in fixed cycle for drilling.
0: Disable
1: Enable
#8124

Mirr img at reset

Select the operation type of the mirror image by parameter setting and the mirror image by external input.
0: The current mirror image is canceled, and new mirror image will start with the machine position at reset
as the mirror center.
1: The mirror center is kept to continue the mirror image.
#8125

Check Scode in G84

Select how to operate when there is no S command in synchronous tapping block.
0: Use the spindle function modal value as S-command value.
1: Output a program error (P181).
#8126 Disable op tone
[M8]
Disable operation tones when operating the keyboard/touch panel.
0: Enable the operation tones
1: Disable the operation tones
[C80]
Not used.
#8127 R-Navi manu F coor
[M8]
Select the initial value of the coordinate system for a manual feed while a machining surface is selected in
the R-Navi function.
0: Feature coordinate system
1: Machine coordinate system
[C80]
Not used.
#8129 Subpro No. select
Select the subprogram No. to be called preferentially in subprogram control.
0: Commanded program No.
1: Four-digit program No. beginning with O No.
2: Eight-digit program No. beginning with O No.
(Note) The program to be called in user macro, figure rotation, macro interruption and compound type fixed
cycle also follows this setting.
#8130 Per-revol. dwell
Select the dwell operation to be carried out when G04 command is given.
0: Apply per-second dwell, irrespective of the synchronous feed mode (G95) or asynchronous feed mode
(G94)
1: Apply per-revolution dwell when synchronous feed mode (G95) is ON, but per-second dwell when asyn-
chronous feed mode (G94) is ON
---Setting range---
0/1
IB-1501279-H 224