G73 W; G73 R; G74 Retract; G76 Last-D - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8054

G73 W

Set the Z-axis cutting margin of the forming rough cutting cycle (G73).
---Setting range---
-99999.999 to 99999.999 (mm)
#8055

G73 R

Set how many times cutting will be performed in the forming rough cutting cycle (G73).
---Setting range---
0 to 99999 (times)
#8056

G74 RETRACT

Set the amount of retract in the cut-off cycle (G74, G75).
---Setting range---
0 to 999.999 (mm)
#8057

G76 LAST-D

Set the amount of final cut-in by the compound type thread cutting (G76).
---Setting range---
0 to 999.999 (mm)
#8058 G76 TIMES
Set how many times the amount of final cut-in cycle (G76 finish margin) will be divided in the compound type
thread cutting (G76).
---Setting range---
0 to 99 (times)
#8059 G76 ANGLE
Set the angle (thread angle) of the tool nose in the compound type thread cutting (G76).
---Setting range---
0 to 99 (°)
#8083 G83S modeM (for M system only)
Set the M command code for changing to the small diameter deep hole drilling cycle mode.
---Setting range---
1 to 99999999
#8084 G83S Clearance (for M system only)
Set the clearance amount for the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 999.999 (mm)
#8085 G83S Forward F (for M system only)
Set the feedrate from the R point to the cutting start position in the small diameter deep hole drilling cycle
(G83).
---Setting range---
0 to 99999 (mm/min)
#8086 G83S Back F (for M system only)
Set the speed for returning from the hole bottom during the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 99999 (mm/min)
219 IB-1501279-H