Sp On 4Th Part Sys; Disable=Input:comp; Disable=Input:var; Display/Set Limit - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8928

SP on 4th part sys

Select which spindle to display in the 4th part system window for the 2-, 3- or 4-part system simultaneous
display.
(Note 1) If you select "00" for the 2-, 3- or 4-part system simultaneous display, the default display is used (1st
spindle on the upper side and 2nd spindle on the lower side).
(Note 2) If you set the same number as, or a greater number than the setting of "#1039 spinno", or if the high-
or low-order setting is "0", the 1st spindle is displayed.
(Note 3) If you set the low-order to F, the screen shows the actual rotation speed, command speed and load
meter of the high-order spindle.
Note that for the 4-counter display in 4-part system simultaneous display, even if the low-order is not
F, the screen shows the actual rotation speed, command speed and load meter of the high-order
and low-order spindles.
(Note 4) [M8] 3- or 4-part system simultaneous display is enabled for a 15- or 19-type display unit only.
[C80] 3- or 4-part system simultaneous display is not available.
---Setting range---
High-order (Select an upper side spindle.): 0 to 8
Low-order (Select a lower side spindle.): 0 to 8, F
#8929

Disable=INPUT:comp

Disable [=INPUT] menu for tool compensation and workpiece coordinate offset values. Fix the setting meth-
od to the incremental value input.
0: Enable
1: Disable
#8930

Disable=INPUT:var

Disable [=INPUT] menu for common variables.
0: Enable
1: Disable
#8931

Display/Set limit

Select the restriction of the connected NC's screen display/settings on/from the remote control tool (NC Mon-
itor2).
0: Permit the screen display/settings
1: Permit the screen display only
2: Restrict the connection
(PR) #8932 Hide measure scrn
Select whether to display the tool measurement screen and workpiece measurement screen.
0: Display
1: Not display
(Note) If the "#11056 Workpiece coordinate system shift OFF" is "0" for the L system, the screen is displayed
as the workpiece coordinate system shift screen even when this parameter is set to "1".
#8933 Disable lngth comp
Set whether to disable the setting of tool shape compensation amount.
0: Not disable
1: Disable
The shape compensation amount covers the following data according to the tool compensation type.
Compensation type I ("1" in "#1037 cmdtyp(command type)")
... Compensation amount (the sum of shape compensation and wear compensation amount)
Compensation type II ("2" in "#1037 cmdtyp(command type)")
... Length dimension and radius dimension
Compensation type III ("3" in "#1037 cmdtyp(command type)")
... Tool length and tool nose R
IB-1501279-H 300