Macro Print File; Dev0 Device Name; Dev0 Baud Rate; Dev0 Stop Bit - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#9054

MACRO PRINT FILE

[M8]
Set the file name to save the output data to a memory card with the DRPNT command for the user macro.
If this parameter is not set, the data will be output under the following name.
dprt$-MMDDhhmmssff
$ is the part system No. in which DPRNT is commanded, MMDDhhmmssff is the current date.
(MM: month, DD: day, hh: hour, mm: minute, ss: second, ff: millisecond)
(Note) This parameter is enabled when "#9007 Macro print directory" is set to "9".
---Setting range---
Program name or file name (32 characters)
#9101

DEV0 DEVICE NAME

[M8]
Set the device name corresponding to the device No.
Set a simple name for quick identification.
---Setting range---
Use alphabet characters, numerals and symbols to set a name within 3 characters.
#9102

DEV0 BAUD RATE

[M8]
Select the serial communication speed.
0: 19200 (bps)
1: 9600
2: 4800
3: 2400
4: 1200
5: 600
6: 300
7: 110
#9103

DEV0 STOP BIT

[M8]
Select the stop bit length used in the start-stop system.
Refer to "#9104 DEV0 PARITY CHECK". At the output of data, the number of characters is always adjusted
for the parity check.
1: 1 (bit)
2: 1.5
3: 2
#9104 DEV0 PARITY CHECK
[M8]
Select whether to add the parity check bit to the data.
ON
OFF
Start bit
Set this parameter in accordance with the I/O device specifications.
0: Not add a parity bit in I/O mode
1: Add a parity bit in I/O mode
1character
b1 b2 b3 b4 b5 b6 bn
Data bit Parity bit Stop bit
231 IB-1501279-H