Illegal Modal G111; No Spec: Axis Name Switch; No Spec: Para Input By Program; Parameter Input Error - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P411

Illegal modal G111

Details
G111 was issued during milling mode.
G111 was issued during nose R compensation mode.
G111 was issued during constant surface speed.
G111 was issued during mixed control (cross axis control).
G111 was issued during fixed cycle.
G111 was issued during polar coordinate interpolation.
G111 was issued during cylindrical interpolation mode.
Remedy
Before commanding G111, cancel the following commands.
Milling mode
Nose R compensation
Constant surface speed
Mixed control (cross axis control)
Fixed cycle
Polar coordinate interpolation
Cylindrical interpolation
P412

No spec: Axis name switch

Details
Axis name switch (G111) was issued though it is out of specifications.
Remedy
Check the specifications.
P420

No spec: Para input by program

Details
Parameter input by program (G10) was commanded though it is out of specifications.
Remedy
Check the specifications.
P421

Parameter input error

Details
The specified parameter No. or set data is illegal.
An illegal G command address was input in parameter input mode.
A parameter input command was issued during fixed cycle modal or nose R compensation.
G10L50, G10L70, G10L100, G11 were not commanded in independent blocks.
Remedy
Correct the program.
P422 Tool/Work shape input error
Details
G10 L100, G10 L101 or G11 has been given together with any other command in a block.
Address P or T has been omitted from G10 L100.
Address C has been omitted from G10 L101.
Remedy
Correct the program.
145 IB-1501279-H