Macro Call Nesting Over; Macro Argument Over; Illegal G67 Command; Macro Alarm Message - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:

Table of Contents

M800/M80/E80/C80 Series Alarm/Parameter Manual

12 Program Errors (P)

Macro call nesting over

The number of macro call nests exceeded the limit imposed by the specifications.

Correct the program so that the macro calls do not exceed the limit imposed by the specifications.

The number of argument sets in the macro call argument type II has exceeded the limit.

Correct the program.

A G67 command was issued though it was not during the G66 command modal.

Correct the program.

Issue G66 command before G67 command, which is a call cancel command.

An alarm command has been issued in #3000.

Refer to the operator messages on the diagnosis screen.

Refer to the instruction manual issued by the machine tool builder.

Brackets [ ] nesting over

Over five times have the parentheses "[" or "]" been used in a single block.

Correct the program so that the number of "[" or "]" is five or less.

Brackets [ ] not paired

A single block does not have the same number of commanded parentheses "[" as that of "]".

Correct the program so that "[" and "]" parentheses are paired up properly.

Calculation impossible

The arithmetic formula is incorrect.

Correct the formula in the program.

Divided by zero

The denominator of the division is zero.

Correct the program so that the denominator for division in the formula is not zero.

The multiplicity of the IF statement exceeded 10 times.

The program is reviewed so that the multiplicity of the IF statement does not exceed 10 times.

IB-1501279-H

Show Quick Links

Table of Contents

C80 series M80 series E80 series