Sensor Over-Travel; Rotary Ax Drawing; Hob Retract On At Alarm; Hob Retract Acceleration Deceleration Off - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#19103

Sensor over-travel

[M8]
Specify the over-travel distance of the sensor that is used for measurement of rotation center error or work-
piece installation error. (allowable excess of sensor, over-stroke)
Set the smallest over-travel distance among all the axes.
The initial approaching speed to the reference sphere is determined according to the over-travel distance.
If the set over-travel distance is greater than the actual distance, the sensor may be damaged.
---Setting range---
0.000 to 100.000 (mm)
#19401 G33.n chamfer spd
Not used.
#19405

Rotary ax drawing

[M8]
Specify this parameter to draw a path of C axis (rotary axis) according to its rotation in the graphic trace and
2D graphic trace.
When "#1013 axname" is set to "C", the axis is handled as a rotary axis.
By setting this parameter to "C", a rotation path around the Z axis on actual workpiece can be expressed.
When the Graphic check rotary axis drawing option or Graphic trace rotary axis drawing option is disabled,
this parameter is ignored.
C: Enable this function
0: Disable this function
(Setting is cleared when "0" is set)
[C80]
Not used.
#19406

Hob retract ON at alarm

Select whether to enable the retract at an alarm during hobbing.
0: Disable
1: Enable
(Standard value: 0)
#19407

Hob retract acceleration deceleration OFF

Select whether to disable the acceleration/deceleration of a retract.
0: Enable
1: Disable
(Standard value: 0)
#19417 Hole dec check 2
This is enabled when #1253 set25 bit2 is 1.
The operation at the hole bottom and the hole drilling stop position is as below.
0: Perform no deceleration check.
1: Perform command deceleration check.
2: Perform in-position check.
<Target fixed cycles>
Machining center: G81, G82, G83, G73
Lathe : G83, G87, G83.2
215 IB-1501279-H