Address-A Error; G200-G202 Cmnd In Tape; Variable Name Illegal; Variable Name Duplicated - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P297

Address-A error

Details
The user macro does not use address A as a variable.
Remedy
Correct the program.
P298

G200-G202 cmnd in tape

Details
User macro G200, G201, or G202 was specified during tape or MDI mode.
Remedy
Correct the program.
P300

Variable name illegal

Details
The variable names have not been commanded properly.
Remedy
Correct the variable names in the program.
P301

Variable name duplicated

Details
A duplicate variable name was found.
Remedy
Correct the program so that no duplicate name exists.
P310 Not use GMSTB macro code
Details
G, M, S, T, or B macro code was called during fixed cycle.
Remedy
Correct the program.
Correct the parameter settings.
P350 No spec: Scaling command
Details
The scaling command (G50, G51) was issued though it is out of specifications.
Remedy
Check the specifications.
P360 No spec: Program mirror
Details
A mirror image (G50.1 or G51.1) command has been issued though the programmable mirror image specifica-
tions are not provided.
Remedy
Check the specifications.
P370 No spec: Facing t-post MR
Details
The facing turret mirror image specifications are not provided.
Remedy
Check the specifications.
IB-1501279-H 142