Plcunit; Mcmpunit; System Type Select; L_Plane - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1005

plcunit

Select the PLC interface setting and display increment.
The PLC interface setting and display increment will follow this specification. Note that the PLC axis will follow
"#1003 iunit".
---Setting range---
[M8]
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
[C80]
B : 1 μm
C : 0.1 μm
(PR) #1006

mcmpunit

Select the machine error compensation setting and display increment.
The parameters related to machine error compensation (backlash, pitch error compensation, etc.) and PLC
interface (external machine coordinate system compensation) will follow this selection.
---Setting range---
[M8]
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
[C80]
B : 1 μm
C : 0.1 μm
(PR) #1007

System type select

Select the NC system type.
0: Machining center system (M system)
1: Lathe system (L system)
(Note 1) If the setting value is out of range, M system will be selected.
#1025

l_plane

Select the plane to be selected when the power is turned ON or reset.
When 0 is specified, 1 is assumed (X-Y plane).e model and specifications.
1: X-Y plane (G17 command state)
2: Z-X plane (G18 command state)
3: Y-Z plane (G19 command state)
#1026 base_I
Set the names of the basic axes that compose the plane.
Set the axis name set in "#1013 axname".
If all three items ("base_I", "base_J" and "base_K") do not need to be set, such as for 2-axis specifications,
input "0", and the parameter will be blank.
Normally, when X, Y and Z are specified respectively for base_l, _J, _K, the following relation will be estab-
lished:
G17: X-Y
G18: Z-X
G19: Y-Z
Specify the desired axis name to set an axis address other than above.
---Setting range---
Axis names such as X, Y or Z
PLC unit
Machine error compensation unit
System type select
Initial plane selection
Base axis I
345 IB-1501279-H