Plc Counter - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters

16.14 PLC Counter

#17200- C000 - C255
17455
Set the time for the counter used with the PLC program (ladder).
(Note1) This setting value is valid when bit selection parameter "#6449/bit1" is set to "0".
(Note2) Setting the counter setting value from the setting and display unit
The counter C setting value can be set with the following two methods.
- Method to validate the setting value (Kn) programmed with the sequence program (fixed counter)
- Method to validate the setting value set from the setting and display unit (variable counter)
(Note3) As described bellow, the setting method of counter C and No. of points can be set with the bit se-
lection parameters (#6454/bit4 to bit7).
- #6454/bit4=0, bit5=0, bit6=0, bit7=0
No. of points: 0
Range: None
Setting method: All fixed counters
- #6454/bit4=1, bit5=0, bit6=0, bit7=0
No. of points: 40
Range: #17200 to #17239
Setting method: Set above range with variable counter.
- #6454/bit4=0, bit5=1, bit6=0, bit7=0
No. of points: 80
Range: #17200 to #17279
Setting method: Set above range with variable counter.
- #6454/bit4=1, bit5=1, bit6=0, bit7=0
No. of points: 120
Range: #17200 to #17319
Setting method: Set above range with variable counter.
- #6454/bit4=0, bit5=0, bit6=1, bit7=0
No. of points: 160
Range: #17200 to #17359
Setting method: Set above range with variable counter.
- #6454/bit4=1, bit5=0, bit6=1, bit7=0
No. of points: 200
Range: #17200 to #17399
Setting method: Set above range with variable counter.
- #6454/bit4=0, bit5=1, bit6=1, bit7=0
No. of points: 240
Range: #17200 to #17439
Setting method: Set above range with variable counter.
- #6454/bit4=1, bit5=1, bit6=1, bit7=0
No. of points: All points
Range: #17200 to #17455
Setting method: All variable counters
---Setting range---
0 to 32767
Counter
629 IB-1501279-H