Mitsubishi Electric M800 Series Manual page 419

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1241 set13
bit0 : Prevention of program error due to incorrect G code combination
When a G code from some modal groups is commanded in the same block as an unmodal G code, a program
error due to incorrect G code combination occurs.
This parameter is used to avoid this program error.
0: The program error(P45) will occur.
1: The program error is avoided, however, a G code from an uncombinable modal group is ignored.
bit1: Interference check at starting up radius compensation (for M system only)
Interference check at starting up nose R compensation (for L system only)
0: In a start-up block, an interference check is not carried out.
1: An error occurs even at a start-up block if an interference occurs.
The error occurs even when the interference avoidance is set to ON (#8102="1"). However, an interfer-
ence check is not carried out when it is set to OFF (#8103="1").
bit4: Plane axis check invalid in fixed cycle for turning machining
Select whether to raise a program error when a fixed cycle for turning machining is commanded in either of
the following conditions:
* The commanded axis does not coincide with the selected plane
* One or both of the selected plane axes have no movement
0: Raise a program error
1: Not raise a program error
bit5: Macro argument L/P valid
Select whether to enable L and P to be used as argument of G(MSTB) macro command or ASCII code macro
command.
0: L and P commands cannot be used.
1: L and P commands can be used as argument.
bit7: Spindle rotation speed during synchronous tap return
Specify how to operate in a sync tap command block if the tap return spindle rotation speed (,S) is lower than
the tap spindle rotation speed (S).
0: Operate at the tap return spindle rotation speed (,S)
1: Operate at the tap spindle rotation speed (S)
IB-1501279-H 402